Click to view our Accessibility Policy or contact us with accessibility-related questions.

 

AIRTAG SETUP INSTRUCTIONS

Need help? That's what we're here for.

We have a video below for both our Carbon Case for AirTag and our AirTag Cash Strap thatcan help you get started.

CONTAINS:

1x  Steel Base

1x  Carbon Case

1x  Extra 3m Tape

1x  Extra Elastic

 

WHAT YOU'LL NEED:

1x  Ridge Wallet

1x  Apple AirTag

1x  T5 Torx Driver

 

STEP 1: SET UP THE CARBON CASE

Before attaching the Carbon Case to your Ridge Wallet, install the Apple AirTag in the Carbon Case. Remove the circular non-stick layer of tape from the underside of the Carbon Case and press the white side of the AirTag securely into the cap. Next, remove the non-stick layer of tape on the Steel Base and firmly press the Carbon Case with AirTag onto the Steel Base.

 

STEP 2: ATTACH THE CASE TO THE WALLET

The easiest place to attach the Carbon Case is on the front plate of the Ridge Wallet.

Loosen the top and bottom screws to the right of The Ridge logo. Slide the tangs of the Carbon Case Base into the slots between the inner and outer plates of the wallet. Tighten the screws to secure the outer plate and lock the Carbon Case in place.

 

TIPS: WHAT ABOUT THE EXTRA ELASTIC?

The extra elastic is for Cash Strap Wallet users who want to completely remove the Strap and fasten the Carbon Case to the backside of the wallet. If you are already using a Money Clipor want to continue using your Cash Strap wallet, then you will not need the extra elastic.

 

REPLACING BATTERIES?

Use the T5 Torx driver to remove the screws closest to the Carbon Case. Remove the Carbon Case from the wallet and flip it over so the bottom of the AirTag is exposed. Replace the batteries in your AirTag as you normally would. Removing the AirTag from the Carbon Case is not necessary.